CX202 10” CONTRACTORS TABLE SAW WITH RIVING KNIFE User Manual
10 Slide the hand wheel onto the hand wheel shaft in front of the saw and secure it using the lock knob provided. Thread the hand wheel handle into
11 Figure-13 Using masking tape to shim the extension wing up If the mating surface of the extension wing tilts up, use a masking tape along the
12 Attach the switch to the front fence rail as shown in figure-17, using screws and washers provided. Figure-17 Installing the switch Install t
13 BLADE GUARD SPREADER Make sure the switch is in the OFF position and the cord is disconnected from the power source. Remove the table insert (i
14 BASIC CONTROLS The basic controls of this machine are shown in the figure-23. Use the figure and read the text to understand what the basic cont
15 CONNECTING TO A DUST COLLECTOR CX202 features a 4” diameter dust port to connect to a dust collector. When connecting to a dust collector, use
16 Figure-25 Riving knife The riving knife is installed when doing non-through cuts using a standard table saw blade and for the cutting operatio
17 OPERATIONS Before performing any of the following operations, make sure all the parts of the machine are assembled properly and you have done
18 the full speed and feed the work-piece through the blade using a push stick, until the work-piece completely passes the saw blade. See figure-28
19 Figure-30 Marking the angle of cut BEVEL CUTS The CX202 blade can be tilted to the left between 0° and 45° by rotating the blade tilt hand
2 TABLE OF CONTENTS General Safety Instructions ... 3 Specific S
20 MAIN TABLE TO BLADE PARALLELISM Your CX202 will give a better result if the main table is parallel to the blade. If it is not parallel, the re
21 hand-wheel. Place the straight edge against the top and bottom part of the spreader or riving knife as shown in figure-34. Figure-34 Using a st
22 ON / OFF SWITCH The CX202 is equipped with a push button switch that will accept a padlock (not included) for locking the switch in the OFF posi
23 CX202 PARTS BREAKDOWN
27 CX202 PARTS LIST
3 GENERAL SAFETY INSTRUCTIONS FOR MACHINES Extreme caution should be used when operating all power tools. Know your power tool, be familiar with
30
31
32
33 WARRANTY Craftex warrants every product to be free from defects in materials and agrees to correct such defects where applicable.
4 NEVER use a saw blade that has missing carbide teeth, loose teeth, or chipped or broken teeth. NEVER stand directly in line with the saw b
5 MODEL CX202 – 10” CONTRACTORS TABLE SAW As part of the growing line of Craftex woodworking equipment, we are prou
6 CX202 – CONTRACTORS TABLE SAW PHYSICAL FEATURES Blade Guard Fence Miter Gauge ON / OFF Switch Blade Tilt Hand Wheel Front Fence Rail Rear Fence Ra
7 SETUP Before setting up your machine you should read and understand the instructions given in this manual. The unpainted surfaces of this table
8 Figure-3 Inventory LIST OF CONTENTS QTY Q. Legs .... 4 R. Brackets ...
9 ASSEMBLY To assemble your CX202, read and understand the text and figures given. Attach the upper smaller brackets to the top holes of each tw
Kommentare zu diesen Handbüchern